9
Figure 4
Deck Roller Height Adjustment
To adjust the height of the rollers found on the rear of
the mowing deck upward or downward, proceed as
follows:
•
Place the deck lift lever in the bottom notch (lowest
position).
•
Remove the clevis pins and hairpin clips from the
deck roller brackets on the left and right sides of the
cutting deck. See Figure 5.
•
Position the deck roller brackets up or down
through the slots on the rear of the deck until
desired position is reached, then re-attach with the
clevis pins and hairpin clips just removed. See
Figure 5.
IMPORTANT:
Be certain that the left roller bracket and
the right roller bracket are set in the same position.
IMPORTANT:
After mounting the cutting deck, perform
any adjustments on the deck, if necessary, prior to
operating the tractor. Refer to page 16 for instructions.
Figure 5
Left-hand Idler Bracket
3/8” Square Hole
Spring
Belt Guard
Idler Pulley
Hairpin Clip
Clevis pin
Deck Roller Bracket
