CHECK YOUR PARTS
Be sure to check the contents of your kit to make sure that everything is
present. Refer to Figure 1 to distinguish a right-hand tine from a left-hand tine.
The Bolo Tine Kit includes the following parts:
Part No.
Description
Qty.
GW-50049-01
Bolo Tine, Right-hand....................................8
GW-50049-02
Bolo Tine, Left-hand ......................................8
1901447
Hardware Kit
710-0514
Hex Screw, 3/8-16 x 1.0 ................................16
712-0798
Hex Nut, 3/8 ..................................................16
736-0169
Lock Washer, 3/8...........................................16
❒
Wrenches (two 9/16 inch)
❒
Screwdriver (medium-sized)
❒
Soft Rubber Mallet
❒
Penetrating Oil
These instructions apply only
to owners of the following
tillers:
❒
BRONCO
TM
Model
❒
SUPER BRONCO
TM
Model
❒
TUFFY
®
Model
Carefully look at the figures
on the opposite side of this
page while following the
instructions.
Thanks for buying new bolo tines. These tines were designed for your model tiller and
will handle all of your tilling needs including sod busting, seedbed preparation,
cultivating, and turning under crop residue.
THANK
YOU!
Bolo Tine Kit
OEM-290-252 / 290-252-081
for BRONCO
TM
, SUPER BRONCO
TM
,and TUFFY
®
Tillers
Installation Instructions
Tine edges can be sharp and
can have slivers that could
cause personal injury. Use
care at all times when
handling tines. The tine hood
edges may also be sharp. To
prevent personal injury, wear
thick gloves when touching
the edges of the hood.
CAUTION
To prevent serious personal injury when removing or installing your bolo
tines:
• Stop the engine, and remove the electric start key (if your tiller features
electric start).
• Let the engine and muffler area cool.
• Disconnect the spark plug wire, and position the wire away from the plug
to prevent accidental starting.
WARNING
Tools Needed
Figure 1: Left-hand tine & Right-hand tine
Blunt
Edge
Blunt
Edge
