11
•
Repeat Auger Control Test to verify proper
adjustment has been achieved. Repeat the
previous steps to provide more slack in the cable, if
necessary.
To Engage Wheel Drive
•
With the engine running near top speed, move the
shift lever into one of the six FORWARD positions
or two REVERSE positions. Select a speed
appropriate for the snow conditions.
NOTE:
Use slower speeds in heavy conditions and
until you are familiar and comfortable with the operation
of the snow thrower.
•
Squeeze the drive control against the right handle
and the snow thrower will move. Release it and the
drive motion will stop.
IMPORTANT:
NEVER move the shift lever without first
releasing the drive control. Doing so will cause
premature wear to the drive system’s friction wheel.
Wheel Steering Controls
The left and right wheel steering controls are located on
the underside of the handles.
•
With the traction control engaged, squeeze the
right wheel steering control to assist in turning right;
squeeze the left control to assist in turning left.
Clean-Out Tool
The clean-out tool is conveniently fastened to the rear
of the auger housing with a mounting clip (Refer to
Figure 8 ). If the chute assembly becomes clogged
during operation, proceed as follows to safely clean the
chute and chute opening:
1.
Release both the Auger Control and the Drive/
Auger Control Lock.
2.
Stop the engine by moving the throttle to the stop
position.
3.
Remove the clean-out tool from the mounting clip.
4.
Use the shovel-shaped end of the clean-out tool to
remove any snow and ice in the chute assembly.
WARNING:
Never use your hand to clear a
clogged chute. Shut off engine and remain
behind handles until all moving parts have
stopped before unclogging. Use the clean-out
tool or a stick to unclog.
5.
Refasten the clean-out tool to the mounting clip on
the rear of the auger housing, re-start the engine.
6.
While standing in the operator’s position (behind
the snow thrower), engage the auger control for a
few seconds to clear any remaining snow or ice
from the chute assembly before continuing to clear
snow.
Operating Tips
WARNING:
The temperature of the muffler
and the surrounding areas may exceed
150°F. Avoid these areas.
•
Allow the engine to warm up for a few minutes. The
engine will not develop full power until it reaches
operating temperature.
•
For the most efficient snow removal, remove snow
immediately after it falls.
•
Discharge the snow downwind whenever possible.
•
Slightly overlap each previous path.
•
Set the skid shoes 1/4" below the shave plate for
normal usage. The skid shoes may be adjusted
upward (to lower the shave plate) for hard-packed
snow. Adjust downward (to raise the shave plate)
when using on gravel or crushed rock.
SECTION 5: MAKING ADJUSTMENTS
WARNING:
NEVER attempt to clean
chute or make any adjustments while engine
is running. Always wear safety glasses
during operation or while performing any
adjustments or repairs.
Drive Control and Shift Lever
To check the adjustment of the drive control and shift
lever, proceed as follows:
•
Move the shift lever into sixth (6) position.
•
With the drive control released, push the snow
thrower forward, then pull it back. The machine
should move freely.
•
Engage the drive control and attempt to move the
machine both forward and back, resistance should
be felt.
•
Move the shift lever into the fast reverse (R2)
position and repeat the previous two steps.
If you experienced resistance rolling the unit, either
when repositioning the shift lever from 6 to R2 or when
attempting to move the machine with the drive control
released, adjust the drive control immediately. To
adjust, proceed as follows:
•
To readjust the drive control cable, unhook the
drive spring (found on the end of the drive control
Summary of Contents for Polar Blast 10530
Page 29: ...29 NOTES ...
Page 30: ...30 NOTES ...
