17
MAINTENANCE AND REPAIR INSTRUCTIONS
4.
Replace cracked, fouled or
dirty spark plug. Set the air
gap at 0.025 in. (0.635 mm.)
using a feeler gauge (Fig.
53).
5.
Install a correctly-gapped
spark plug in the cylinder
head. Turn the 5/8 in. socket
clockwise until snug.
If using a torque wrench torque
to:
110-120 in.•lb. (12.3-13.5 N•m)
Do not over tighten.
SPARK ARRESTOR MAINTENANCE
1.
Remove the rear engine cover. See
Rocker Arm
Clearance
.
2.
With a flat blade screwdriver or Torx T-20 bit and a T-25
bit, remove the screws attaching the spark arrestor cover
to the muffler (Fig. 54).
3.
Pull the tab on the spark arrestor cover out of the muffler.
Remove the spark arrestor cover.
4.
Remove the spark arrestor screen from the spark arrestor
cover.
5.
Clean the spark arrestor screen with a wire brush or
replace it.
6.
Reinstall the spark arrestor screen, spark arrestor cover
and screws.
CLEANING
Use a small brush to clean off the outside of the unit. Do not
use strong detergents. Household cleaners that contain
aromatic oils such as pine and lemon, and solvents such as
kerosene, can damage plastic housing or handle. Wipe off any
moisture with a soft cloth.
STORAGE
• Never store the unit with fuel in the tank where fumes may
reach an open flame or spark.
• Allow the engine to cool before storing.
• Lock up the unit to prevent unauthorized use or damage.
• Store the unit in a dry, well-ventilated area.
• Store the unit out of the reach of children.
LONG TERM STORAGE
1.
Drain all gasoline from the gas tank into a container. Do
not use gas that has been stored for more than 60 days.
Dispose of the old gasoline in accordance to Federal,
State, and Local regulations.
2.
Start the engine and allow it to run until it stalls. This
ensures that all gasoline has been drained from the
carburetor.
3.
Allow the engine to cool. Remove the spark plug and put
5 drops of high quality motor oil into the cylinder. Pull the
starter rope slowly to distribute the oil. Reinstall the spark
plug.
NOTE:
Remove the spark plug and drain all of the oil from
the cylinder before attempting to start the trimmer
after storage.
4.
Change the oil, referring to
Changing the Oil
. Dispose of
the old oil in accordance to Federal, State and Local
regulations.
5.
Thoroughly clean the unit and inspect for any loose or
damaged parts. Repair or replace damaged parts and
tighten loose screws, nuts or bolts. The unit is ready for
storage.
TRANSPORTING
• Allow the engine to cool before transporting.
• Secure the unit while transporting.
• Drain the gas tank before transporting.
• Tighten gas cap before transporting.
Muffler
Spark Arrestor Screen
Diverter
T-20 Screw
Slot
T-25 Screw
WARNING:
To avoid serious personal injury,
always turn your unit off and allow it to cool before
you clean or service it.
0.025 in.
(0.635 mm.)
Fig. 53
Fig. 54
WARNING:
To avoid serious personal injury,
always turn your unit off and allow it to cool before
you clean or service it.
Summary of Contents for TB525ET
Page 64: ...NOTES...
Page 65: ...NOTES...
