7.
Tighten the clamp screws evenly, until the J-handle is
secure.
INSTALLING THE CUTTING SHIELD
Use the following instructions if the cutting attachment shield
on your unit is not installed or if you ever need to re-install it.
1.
Place the cutting attachment shield onto the shaft housing
above the clamp assembly (Fig. 3).
2.
Push the cutting attachment shield down to the top of the
cutting attachment assembly. Then rotate the shield until
its screw holes line up with the holes in the cutting
attachment. The shield guard should fit into the recessed
On some units, the J-handle may be pre-installed. In this case
you must loosen screws and adjust the handle to fit the operator.
Go to step 5 if the J-handle is pre-installed.
INSTALL AND ADJUST THE J-HANDLE
1.
Place the J-handle between the top and middle clamp
pieces (Fig. 1).
2.
While holding the three
pieces together, install
the four (4) screws
through the top clamp
and into middle clamp.
NOTE:
The holes in the top
and middle clamp
will line up only
when assembled
correctly.
3.
Place the clamps and
the J-handle over the
shaft housing and onto the bottom
clamp.
4.
Hold each hex nut in the bottom
clamp recess with a finger. Start
screws with a large Phillips
screwdriver. Do not tighten until
you make the handle adjustment.
5.
Slide the J-handle in or out until the
arrow/white line on the decal touches the clamp assembly
(Fig. 2). You must first loosen the screws if the handle is
pre-installed.
6.
While holding the unit in the operating position (Fig. 15),
position the J-handle to the location that provides you the
best grip.
ASSEMBLY INSTRUCTIONS
(4) Screws
Top Clamp
J-Handle
Middle Clamp
Bottom Clamp
Nuts
Fig. 1
Decal
Cutting Attachment
Shield
Fuel Cap
Throttle
Control
J-Handle
Cutting Attachment
Shaft Grip
Primer
Bulb
Oil Fill
Plug
Choke Lever
Shaft
Starter
Rope
Grip
Line
Cutting
Blade
Spark Plug
Muffler
EZ-Link™
On/Off Stop
Control
KNOW YOUR UNIT
Air Filter
Cover
WARNING:
Never operate the trimmer without
the cutting attachment shield in place to prevent
serious personal injury.
(4) Screws
Clamp
Cutting Attachment
Shield
Recessed Pocket
WARNING:
To avoid serious personal injury, the
cutting attachment shield MUST be in place at all
times while operating the unit as a trimmer.
5
Fig. 2
Fig. 3
Fig. 4
Hanger
Height
Adjustment
Wheel
Edger Blade
Blade
Shield
Gear
Housing
Summary of Contents for TB525ET
Page 64: ...NOTES...
Page 65: ...NOTES...
