Cutting Head Shield
Fuel Cap
Throttle
Control
D-Handle
Cutting Head
Shaft
Grip
Primer
Bulb
Choke Lever
Spark Plug
On/Off
Stop
Control
Shaft Housing
Starter
Rope Grip
Line Cutting Blade
Muffler
Air Filter
Cover
EZ-Link
TM
Throttle
Lock-out
Shoulder
Strap Clip
4
KNOW YOUR UNIT
ASSEMBLY INSTRUCTIONS
ADJUSTING THE D-HANDLE
1. Loosen the bolt on the handle just enough
to move it (Fig. 1).
2. While holding the unit in the operating
position (Fig. 16), move the D-handle to the
location that provides the best grip.
3. Tighten the bolt until the D-handle is secure.
(Fig. 1)
INSTALL THE CUTTING HEAD SHIELD
1. Place the cutting head shield onto the guard
mount bracket, making sure to align the
holes on the shield with the ones in the
guard mount bracket. (Fig. 2)
2. Take the 4 shield screws and screw each
one into the shield until finger tight.
3. Using a Phillips screwdriver, tighten the screws
until the shield is firmly in place. (Fig. 2)
INSTALL THE SHOULDER SUPPORT
(SOLD SEPARATELY)
1. Put the shoulder support on using the clip.
(Fig. 3).
2. Adjust by lifting slightly on the rear of the
lower clip then push or pull the loose end of
the strap length to fit the operator’s size
and comfort. (Fig. 4).
3. Attach the shoulder clip to the unit. (Fig. 5)
APPLICATIONS
As a trimmer:
• Cutting grass and light weeds.
• Edging
• Decorative trimming around
trees, fences, etc.
Other optional accessories may
be used.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
D-Handle
Bolt
6 in.
(15.24 cm)
Minimum
Guard
Mount
Bracket
Screw (4)
Cutting
Head
Shield
Adjustment
Tab
Support
Clip
Support
Fitting
TOOLS REQUIRED:
• Phillips Screwdriver
• 3/8” Socket
