Manual
SLIM-
PWR44
INSTALLING THE TRUNAMI:
PLEASE NOTE:
This subwoofer MUST be firmly secured to the wall. This model produces a LOT of bass and will
rattle the walls if not installed properly!
At this point the location for the subwoofer should have already been finalized. The wall should be drywalled, textured
and painted before installation of the subwoofer.
Cut a small (6” x 6”) hole in the drywall
in the center of the chosen mounting location to check for obstructions
within the wall cavity. If there are any wires, plumbing or stray nails or screws that might interfere with installation they
need to be taken care of. You should also make sure the speaker wire it is out of the way for when the full opening will
be cut.
The opening that will need to be cut for the Trunami is 14.5” wide x 17.5” tall. Before marking the opening, first verify
that the width of the stud bay is between 14.3” and 15.0” wide and that you have at least 17.5” vertical space to
install your subwoofer. Carefully remove the subwoofer and grill from the packaging. Holding the grill against the wall,
determine the height you want the subwoofer to be installed at. Using a straight edge or a level, draw a line .75” (3/4”)
above the bottom edge where you want the grill to be installed that is 14.5” wide and centered within the stud bay.
From each end of this line draw a line vertical that is 17.5” tall. Verify that the ends these lines are 14.5” apart and are
horizontal from each other. Using the straight edge, connect the ends with a 4th line, forming a rectangle.
Using an appropriate cutting tool, cut along the lines you have just marked.
Be careful to avoid cutting the
speaker wire
for your subwoofer. If the distance between the studs is narrower than 14.5” cut as close to the inside
edge of the studs as possible.
CAUTION:
Before connecting your Trunami make sure to turn off the power to your amplifier before making any
electrical connections. When turning your amplifier on for the first time, make sure the volume is all the way down.
Connect the speaker wires to the screw terminals on the Trunami, making sure to observe the correct polarity (+, -).
DO NOT reverse
the polarities when connecting the subwoofer or amplifier. Doing so will put the speaker out of
phase and will cause poor sound and a lack of bass.
Place the Trunami in the stud bay opening, making sure not to pinch or accidentally disconnect the speaker wire.
Using the screws provided, secure the subwoofer to the wall studs through the 8 holes in the metal frame. If you
choose to use a different type of screw, make sure that they are big enough that the heads will not fit through the
holes in the metal frame.
PLEASE NOTE AGAIN:
You MUST make sure that EVERYTHING is firmly secured to prevent rattling or unwanted
noise. This model produces a lot of bass and will rattle anything and everything that is not secured or installed
properly!
www.TruAudio.com
888.858.1555
198 North Old Highway 91 Hurricane, UT 84737
Manual
Trunami
