Page 7
Control Wire
Mounting Plate
Screw (A)
(Optional Installation)
Screw B
fig. 7.5
6. INSTALLING THE EXTERIOR ASSEMBLY
Work with the Door Open for easy access
a. Unpack the Exterior Assembly. Use care to not scratch the green circuit board during handling and
installation.
b. Check that the rubber gasket is properly seated on the Exterior Assembly. ( see figure 6 )
c. Insert the Exterior Assembly onto the door with the tailpiece going through the Deadbolt Latch cross
shaped spindle connector in the
VERTICAL POSITION
. Route the Control Wire through the door below
the Deadbolt Latch. (see figure 6)
a. From the side marked “This side against door”, route the Control Wire through the rectangular slot in
the Mounting Plate
b. Place Mounting Plate against door with tailpiece passing through the center hole in the three hole set
c. Secure the Mounting Plate to the Exterior Assembly using Screw B (2 ea)
d. Hand tighten with a screwdriver leaving loosely connected
e. Check that the Rubber Gasket is properly aligned and correct as necessary.
f. Check vertical alignment of the lock
g. Tighten with a hand held screwdriver.
DO NOT OVER TIGHTEN
7. SECURING THE EXTERIOR ASSEMBLY TO THE DOOR
NOTE:
Unpack the Interior Assembly. Remove the battery cover by sliding the cover upward. Locate the one
screw holding the Mounting Plate to the Interior Assembly. Remove the screw to release the Mounting Plate
from the Interior Assembly.
NOTE: TAILPIECE MUST BE POSITIONED VERTICALLY
Right Handed Door View
Control Wire
Latch Hole
Tailpiece
(Vertical)
fig. 6.5
fig. 6
fig. 7
Mounting Plate
Screw B
Summary of Contents for 0711016
Page 1: ...Page 1 0711016 ...
