Page 12
NOTE:
When battery is under low voltage, the lock will give the (Low Battery Warning: Beeps and
LED flashes red for 5 seconds). During this time your lock can still work. However once the voltage
is lower than 4.3V (called Super-Low Voltage), the operation of the locking and unlocking will not
work, user must replace batteries immediately.
Unlock / Valid programming:
1 long beep and LED illuminates green
Lock:
2 short beeps and LED illuminates red
Invalid Programming:
2 short beeps and LED flashes red twice
Low Voltage:
Beeps for 5 seconds
(7/9 times depends on operation is unlock/lock)
Super Low Voltage:
4 short beeps and LED flashes red four times
4 Incorrect code entry attempts:
2 short beeps and LED illuminates red each attempt
Power on:
1 long beep and 1 short beep and LED illuminates green
Chip Reset:
1 long beep and 1 short beep and LED illuminates green
(may occur several times or once in a while)
Lock Error:
3 long beeps LED flashes red three times
Repeat operation after Lock Error:
2 short beeps three times LED flashes red six times
CONSUMER FRIENDLY MESSAGE GUIDE
My Codes:
Date Created
Programming Code
(6 digits) / /
User Code 01
(4-8 digits) / /
User Code 02
(4-8 digits) / /
User Code 03
(4-8 digits) / /
User Code 04
(4-8 digits) / /
User Code 05
(4-8 digits) / /
User Code 06
(4-8 digits) / /
User Code 07
(4-8 digits) / /
User Code 08
(4-8 digits) / /
User Code 09
(4-8 digits) / /
User Code 10
(4-8 digits) / /
Programming Record
