Page 13
Unlock / Valid programming:
1 long beep and LED illuminates green
Lock:
2 short beeps and LED illuminates red
Invalid Programming:
2 short beeps and LED flashes red twice
Low Voltage:
Beeps for 5 seconds
(7/9 times depends on operation is unlock/lock)
Super Low Voltage:
4 short beeps and LED flashes red four times
4 Incorrect code entry attempts:
2 short beeps and LED illuminates red each attempt
Power on:
1 long beep and 1 short beep and LED illuminates green
Chip Reset:
1 long beep and 1 short beep and LED illuminates green
(may occur several times or once in a while)
Lock Error:
3 long beeps LED flashes red three times
Repeat operation after Lock Error:
2 short beeps three times LED flashes red six times
INSTALLATION TROUBLE SHOOTING
Issue
Solution
Lock will not function
electronically
• Check that all batteries are fresh high quality
Alkaline Batteries
• Check for proper polarity (+ -) of all batteries
• Check that the Control Wire is attached to the
Interior Assembly
Latch is sticking.
Installation screws of the lock may be too tight and have to be
loosened
• Remove Interior Assembly
• Slightly loosen the Mounting Plate Screws
• Lock and unlock using the Key
• Reattach Control Wire and Interior Assembly
Strike Plate
Battery Cover
Interior Assembly
Keys
Control Wire
Exterior
Assembly
Rubber Gasket
Vetical Tailpiece
Mounting
Plate
Latch
A - 5/16” (8mm) screws
C - Optional
3/4” (19mm) screw
C -3/4” (19mm) screws
B - 7/8” (22mm) screws
D - 1” (25mm) Screw
INSTALLATION OVERVIEW
