Page 7
13. Installing Batteries
a. Insert 4 AA high quality Alkaline batteries into the Battery Compartment in the
direction noted +/- on the Compartment. The Lock will beep 2 times, the keypad
will illuminate blue, and the TRU-BOLT button will flash green twice to signify that
it has received power (Figure 13a).
b. Slide the Battery Cover down into the track on the Interior Assembly to cover
the batteries (Figure 13b).
14. Testing Lock
With the Door Open
a. Test the Lock using the Interior Lever. The Latch should move smoothly.
b. Test the lock using the Keypad. To lock press and then press “1234”
to unlock.
INSTALLING INTERIOR ASSEMBLY (CONT.)
NOTE: Do not touch the Keypad until the blue light turns off.
Do not use rechargeable batteries or non-alkaline batteries.
Strike Plate
Battery Cover
Interior Assembly
Keys
Control Wire
Exterior
Assembly
Rubber Gasket
Vetical Tailpiece
Mounting
Plate
Latch
A - 5/16” (8mm) screws
C - Optional
3/4” (19mm) screw
C -3/4” (19mm) screws
B - 7/8” (22mm) screws
D - 1” (25mm) Screw
INSTALLATION OVERVIEW
Override
Access Key
Exterior Assembly
Interior Assembly
Interior
Lever
Battery
Cover
Light Indicator
Keypad
Figure 13a-b
