60
C
AR
E
AND
M
AIN
TENANC
E
Maintenance Schedules
C
ARE
AND
M
AINTENANCE
To extend the life and appearance of your TRUE Z-Series treadmill, we
recommend that you monthly:
1. Clean the treadmill of dust and dirt that might accumulate under and
behind the treadmill. Vacuum small rubber particles from the soles of
running shoes that accumulate alongside the belt and behind the
machine.
2. Inspect the autowaxer for sufficient wax in the wax channel.
a. Lay treadmill on its side.
b. Pull back the treadbelt (on the bottom of the treadmill) to expose
the wax channel.
c. The wax channel should be at least ¼” thick at its thinnest point.
d. Feel along the full length of the wax channel for consistent
thickness.
e. Call authorized service technician to replace wax channel if it is
less than ¼” thick at any point.
NOTE: To prevent damage to the treadbelt, do not allow the treadmill to
run without sufficient wax in the wax channel.
Once every three (3) months we recommend that the motor cover be re-
moved and the motor area vacuumed thoroughly to remove dust and par-
ticles. Only authorized service personnel should perform this procedure
as only authorized service technicians are allowed access to the area under
the motor hood. A thorough visual inspection should be performed at this
time as well. Have the technician check for tight wire harness connections,
damaged motor or power wires, tight motor and tensioner bolts, tight
ground screw connections and wire tie downs, properly attached incline
motor cotter pin and clevis pin, and tight motor controller and interface
screws.
Expert service and maintenance at a modest cost are available through your
factory trained authorized TRUE dealer. He maintains a stock of repair
parts and has the technical knowledge to meet your service needs.
Z 7 Tr e a d m i l l O w n e r ' s G u i d e
M
ONTHLY
C
ARE
AND
S
ERVICE
M
ONTHLY
C
ARE
AND
S
ERVICE
