GDM HST02
www.truemfg.com
TEC_TM_158 | REV. A | EN
06/28/2022
Page 10 of 28
Cabinet Setup
Shelf
Clip
Shelf
Shelf
Organizer
Pillaster
(I-beam)
Shelf
Standards
Retainer
Clip
WARNING
– DO NOT use pliers or
any crimping tools when installing
shelf clips. Altering shelf clips in any
way can lead to shelving instability.
Shelf Installation
Procedure
1.
Hook the shelf clips into the shelf standards. See fig. 1.
2.
Push up on the bottom of the clip. See fig. 2.
NOTE: You may need to squeeze or twist the bottom of the
shelf clip for proper installation. Position all four shelf clips
equal in distance from the floor for flat shelves.
3.
Ensure the shelf clip is not loose or able to wiggle out of the
shelf standard. See figs. 3 and 4.
4.
Place the shelves on the shelf clips with the cross support bars
facing down.
NOTE: Be sure all shelf corners are properly seated.
Installation Tips
• Install
all
the shelf clips before installing any shelves.
• Start at the bottom shelf and work your way up.
• Always lay the back of each shelf down on the rear clips before
the front.
TrueTrac Organizers
TrueTrac organizers come with a package of shelf retainer clips.
Install the clips on the side of the organizer towards the rear.
See fig. 5
Shelf Adjustment
Shelving is adjustable for customer application. This cabinet meets
the IEC Shelf Weight Capacity of 47lb/ft2 (230kg/m2).
Fig. 1.
Installing top tab of shelf clip.
Fig. 2.
The bottom tab of the shelf clip
will fit tightly
Fig. 3.
You may need to squeeze or twist
the bottom of the shelf clip to install.
Fig. 4.
Installed shelf clip.
Fig. 5.
Shelf clips and shelf/TrueTrac organizer configuration.
