True Professional 24 Series Installation Guide
20
Tools Needed:
• Phillips Screwdriver
• 3/8” wrench
• 1/8” Drill Bit
• Ten (10) Screws #6
SEE PAGES 14-17 FOR OvERLAy PANEL DIMENSIONS
BEFORE INSTALLING.
FOR EASy OvERLAy INSTALLATION REFRIGERATOR
DOOR REMOvAL IS REQUIRED.
NOTE: DO NOT INSTALL A SOLID PANEL ON A
GLASS DOOR. THIS MAy CAUSE MOISTURE TO FORM
BEHIND THE PANEL RESULTING IN DAMAGE.
1. Open front door and pull grill forward to remove.
2. To remove door back out two bottom hinge screws
with a 3/8” wrench. Secure door while removing
screws. Remove two Phillips screws from the top
hinge. Save all these screws for later reinstall.
3. Lay door on a safe solid surface. If retrofitting glass
door model be careful not to damage glass. Lay
cardboard or other safe material down before working
on the door.
4. Remove door gasket from the inside of the door
frame. Place gasket to the side for later reinstall.
5. There are pre marked areas on the front of the door.
Drill these pre marked holes with 1/8” drill bit. make
sure to go all the way through the door.
NOTE: IF HANDLE IS BEING USED ON OvERLAy
INSTALL IT BEFORE STEP 8 (See Image A). FOR BEST
INSTALLATION, SCREWS ATTACHING HANDLE
SHOULD BE RECESSED.
6. It is recommended to clamp the door front on top
of the overlay before drilling pilot holes and installing
anchor screws. The clamp ensures the overlay panel
and door stay aligned with each other while installing.
Once panel is clamped in place, pilot holes may be
drilled into the panel from the rear side of the door.
1
4
3
2
Remove
screws from
top and
bottom hinge
5
SOLID & GLASS OVERLAY PANEL INSTALLATION
Summary of Contents for TBC-24-R/L-OG-A
