............ www.truemfg.com ............
............ www.truemfg.com ............
INSTALLATION / OPERATION INSTRUCTIONS
INSTALLATION / OPERATION INSTRUCTIONS
True Food Service Equipment, Inc.
True Food Service Equipment, Inc.
5
5
5
5
Step 2
A.
Place packing material behind cabinet as a
cushion. Carefully lay the unit on its back to
remove skid.
When lifting unit remember to
leave the cabinet upright for 24 hours before
plugging into power source.
B.
Remove skid by unscrewing all base rail anchor
brackets. Place skid to the side.
C.
Carefully lift cabinet upright.
LOCATING
Removing
skid from
bottom of
cabinet.
Step 3
A.
Set unit in its final location. Be sure there is ade-
quate ventilation in your room. Under extreme heat
conditions, (100°F+, 38°C+), you may want to install
an exhaust fan.
Warning
Warranty is void if ventilation is insufficient.
B.
Proper leveling of your True cooler is critical to
operating success (for non-mobile models). Effective
condensate removal and door operation will be
effected by leveling.
C.
The cooler should be leveled front to back and
side to side with a level.
D.
Ensure that the drain hose or hoses are posi-
tioned in the pan.
E.
Free plug and cord from inside the lower rear of
the cooler (do not plug in).
F.
The unit should be placed close enough to the
electrical supply so that extension cords are never
used.
Warning
Compressor warranties are void if the unit is more
than 9 ft. (3 m) from plug-in connection or
extension cord is used to supply power to unit.
LEVELING
REMOTE UNITS (This section applies to
remotes only!)
•
Remote cabinets must be ordered as remote.
We do not recommend converting for a standard
self contained to remote system.
•
All remote cabinets must be hard wired.
•
No castors available.
•
All remote cabinets come standard using 404A
refrigerant.
•
All remote units come standard with expansion
valve, liquid line solenoid, heated condensate
pan, and defrost timer when applicable.
• Contact True Technical Service for BTU
requirements.
•
No wiring necessary between cabinet and
condensing unit.
•
All remote condensing units purchased from
True are 208/230 volts single phase.
If you have any questions regarding this sec-
tion, please call True at 1-(800)-325-6152.