............ www.truemfg.com ............
True Food Service Equipment, Inc.
3
3
The power cord of this appliance is equipped
with a 3-prong (grounding) plug which mates
with a standard 3-prong (grounding) wall outlet to
minimize the possibility of electric shock hazard
from this appliance.
Have the wall outlet and circuit checked by a
qualified electrician to make sure the outlet is
properly grounded.
If the outlet is a standard 2-prong outlet, it is your
personal responsibility and obligation to have it
replaced with the properly grounded 3-prong wall
outlet.
The unit should always be plugged into it’s own
individual electrical circuit, which has a voltage
rating that matches the rating plate.
This provides the best performance and also
prevents overloading building wiring circuits which
could cause a fire hazard from overheated wires.
Never unplug your freezer by pulling on the power
cord. Always grip plug firmly and pull straight out
from the outlet.
Repair or replace immediately all power cords that
have become frayed or otherwise damaged. Do not
use a cord that shows cracks or abrasion damage
along its length or at either end.
When removing the freezer away from the wall, be
careful not to roll over or damage the power cord.
IMPORTANT ELECTRICAL SAFETY INFORMATION
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this appliance must be properly grounded.
WARNING!
USE OF EXTENSION CORDS / ADAPTER PLUGS
NEVER USE AN EXTENSION CORD! NEVER USE AN ADAPTER PLUG!
Do not use adapter plugs or extension leads as
these can cause safety issues and early failure of electrical components. The use of adapters and extension cords will
invalidate your warranty.
WARNING
Compressor warranties are void if compressor burns out due to low voltage.
WARNING
Power supply cord ground should not be removed!
NOTE
To reference wiring diagram - Remove lower rear grill. Wiring diagram is positioned on the inside cabinet wall.
SAFETY INFORMATION
