TOAM | OPEN AIR MERCHANDISER
truemfg.com
TEC_TM_012 REV. B
09/25/2020
Page 6 of 20
Installation (cont.)
Uncrating
Tools Required
• Adjustable wrench
• 3/4" socket wrench
• 1/4" socket wrench
• Level
The following procedure is recommended for uncrating the unit:
1.
Remove the outer packaging (cardboard and bubbles or
styrofoam corners and clear plastic). See fig. 1. Inspect for
concealed damage. Again, immediately file a claim with the
freight carrier if there is damage.
NOTE:
Move the unit as close as possible to the final
location before removing the wooden skid.
2.
With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the cabinet. See fig. 2.
NOTE:
Some models may require removing the front and/
or rear grill to access the shipping bolts. See figs. 3 and 4.
Remove the grills with a 1/4" socket wrench, if so equipped.
3.
Install the included leveling legs (see Installing Standard
Leveling Legs), optional 6" leveling legs or castors (see Installing
Optional 6" Leveling Legs or Castors), if so equipped.
NOTE:
With the shipping bolts removed, rotate the cabinet
on the skid to gain access.
If leveling legs or castors are not to be used, remove the
cabinet from the wooden skid. Place the skid to the side.
NOTE:
When lifting the unit, do not use countertops, doors/
drawers, or grills as a lifting point. Also, remember to leave
cabinet upright for 24 hours before plugging into a power
source. Keys for cabinet with door locks are located in the
warranty packet.
Fig. 1.
Remove the outer packaging.
Fig. 3.
Remove the screws. Pull the front grill to release it from the magnetic brackets.
Fig. 4.
Remove the screws and detach the rear grill.
Fig. 2.
Remove the skid bolts on the front and back.
