CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100
10
BIKE ASSEMBLY STEPS:
Step 1: Rear Stabilizer Bar:
a
) Rotate the frame forward on the Front
Stabilizer bracket (metal).
*At least one person should hold the frame,
while another person completes the remaining
Rear Stabilizer installation steps
b
) For each screw, install through split washer
then flat washer
c
) Insert Rear Stabilizer into the metal bracket
d
) Install each screw through the bottom of the
metal bracket, then through the Rear Stabilizer
e
) Tighten using the provided hex wrench
Hardware Required:
2 M8 x 70 Screws
2 M8 Washers
2 M8 Spring Washers
Step 2: Front Stabilizer Bar:
a
) Rotate the frame backwards on the Rear
Stabilizer
*At least one person should hold the frame,
while another person completes the remaining
Front Stabilizer installation steps
