CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100
11
BIKE ASSEMBLY STEPS (continued):
Step 2: Front Stabilizer Bar (continued):
b
) For each screw, install through split washer
then flat washer
c
) Insert Front Stabilizer into the metal bracket
Install each screw through the bottom of the
metal bracket, then through the Front Stabilizer
d
) Tighten using the provided hex wrench
Hardware Required:
2 M8 x 70 Screws
2 M8 Washers
2 M8 Spring Washers
Step 3: Seat Saddle:
a
) Remove the flat washers and nuts from the 3
threaded rods on the bottom of the Seat Saddle
b
) Insert Seat Saddle onto the Seat Post
Mounting Plate; the threaded rods on the
bottom of the Seat Saddle will align with the 3
openings on the Seat Post Mounting Plate
c
) For each threaded rod, install flat washer
followed by nut
d
) Tighten using the provided wrench
Hardware Required:
*Included with seat saddle
Preparation for Step 4:
a
) Install the Mast Boot component (including
rubber gasket) onto the Front Mast tube
b
) Verify that the Mast Boot is installed in the
correct orientation as shown.
