CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100
14
BIKE ASSEMBLY STEPS (continued):
Step 6: Mast Boot
a
) Pull down the Mast Boot
b
) Attach the Mast Boot to the plastic shrouds
by tightening both screws with a Phillips head
screwdriver (not provided).
Hardware Required:
2 M4 x 10 Screws
Step 7: Handlebar Cable Routing:
a)
While at least one person holds the
Handlebar, another person should direct the
Handlebar Cables through the Front Mast.
Step 8: Handlebar:
a
) Insert the Handlebar U-bracket onto the
Front Mast.
DO NOT PINCH CABLES.
b
) For each screw, install through split washer
then flat washer
c
) Secure the Handlebar to the Front Mast by
tightening all 3 screws with the provided hex
wrench
Hardware Required:
2 M8 x 70 Screws
2 M8 Washers
2 M8 Spring Washers
