CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100
15
BIKE ASSEMBLY STEPS (continued):
Step 9: Console Mounting:
a
) The screws used to attach the Console are
provided in the Console packaging
b
) Align the back of the Console with the Front
Mast Console Mounting Plate
c
) Attach the Console to the Mounting Plate by
tightening all 4 screw with a Phillips head
screwdriver (not provided)
Hardware Required:
*Included with console
Step 10: Cable Connections :
a)
Locate the Ground Screw; pre-installed into
the Front Mast Mounting Plate
b)
Remove the Ground Screw with a Phillips
head screwdriver (not provided)
c)
Insert the shaft of the Ground Screw through
the metal ring
s
attached to the
c
onsole
g
round
w
ire
and heart rate board ground
wire.
d)
Re-attach the Ground Screw to the Front
Mast Mounting Plate
e)
Verify that the metal Ground Ring
s
are
compressed between the head of the Ground
Screw and the Front Mast Mounting Plate
Note:
Confirm
the console ground wire and the
Heart Rate Board ground wire are both secured
to the console front mast with the ground
screw.
