CHAPTER 2: ASSEMBLY GUIDE
Truefitness.com / 800.426.6570 / 636.272.7100
15 of 34
ASSEMBLY STEPS:
Step 2 Front Stabilizer Bar:
b) For each screw, install through split washer then flat
washer
c) Insert Front Stabilizer into the metal bracket Install each
screw through the bottom of the metal bracket, then through
the Front Stabilizer
d) Tighten using the provided hex wrench
Hardware Required:
Step 3 Seat Saddle:
a) Remove the flat washers and nuts from the 3 threaded rods
on the bottom of the Seat Saddle
b) Insert Seat Saddle onto the Seat Post Mounting Plate.
Note: The threaded rods on the bottom of the Seat Saddle will
align with the 3 openings on the Seat Post Mounting Plate.
c) For each threaded rod, install flat washer followed by nut.
d) Tighten using the provided wrench.
Hardware Required:
*Included with seat saddle.
Step 4 Preparation:
a) Install the Mast Boot (including rubber gasket) onto the
Front Mast tube.
b) Verify that the Mast Boot is installed in the correct
orientation as shown.
2 M8 x 70 bolts
2 M8 Washers
2 M8 Lock Washers
Mast Boot
Summary of Contents for UC900
