CHAPTER 4: CARE & MAINTENANCE
Truefitness.com / 800.426.6570 / 636.272.7100
27 of 41
CARE & MAINTENANCE:
It is important to perform the minor maintenance tasks described in this section. Failure to maintain the elliptical as
described here could void the TRUE Fitness Warranty. To reduce the risk of electrical shock, always unplug the unit from
its power source before cleaning or performing any maintenance tasks.
Inspection:
TRUE Fitness is not responsible for performing or scheduling regular maintenance or inspections. Users should inspect the
elliptical daily. Check for worn, frayed or missing safety lanyards. Replace missing or worn safety lanyards immediately.
Do not exercise on the elliptical without attaching the safety clip to your clothing. Look and listen for slipping belts, loose
fasteners, unusual noises, worn or frayed power cords, and any other indications that the equipment may be in need
of service. If any of these are noticed, obtain service. Do not attempt to use the elliptical until proper service has been
performed or damaged parts have been replaced.
Important:
If you determine that the elliptical needs service, make sure that the elliptical cannot be used inadvertently. Turn the unit
off, and then unplug the power cord from its power source. Remove the magnetic safety key and safety clip and store it in a
safe place. Make sure other users know that the elliptical needs service.
*To order parts or to contact a TRUE Authorized Service representative, please visit www.truefitness.com.
CLEANING THE EQUIPMENT:
After Each Use:
• Use GymWipes™ Antibacterial wipes or spray a solution of 30 parts water to 1 part mild detergent to dampen a soft
cloth and wipe all exposed surfaces.
• Use a LCD/screen cleaner or spray a solution of 1 part 91% isopropyl alcohol and 1 part water to dampen a soft cloth
and wipe the surface of the console. This helps remove fingerprints, dust, and dirt.
Weekly:
• Vacuum any dust or dirt that might have accumulated under or around the elliptical, any motor cover vents and under
the straddle covers. Clogged air vents can prevent adequate cooling to the drive motor, incline motor, and motor
control board causing a shortened life.
• Check for proper running belt alignment and tension. If running belt adjustment is required, see sections “RUNNING
BELT ALIGNMENT” and “TENSIONING THE RUNNING BELT” in the following pages.
CAUTION:
Do not use any acidic cleaners. Doing so will weaken the paint or powder coatings and may void the TRUE Fitness
Warranty. Never pour water or spray liquids on any part of the elliptical. Allow the elliptical to dry completely before
using. Frequently vacuum the floor underneath the unit to prevent the accumulation of dust and dirt, which can affect the
smooth operation of the unit. Use a soft nylon scrub brush to clean the running belt. Do not clean directly underneath the
treadbelt. Most of the working mechanisms are protected inside the motor cover and base of the elliptical. However, for
efficient operation, the elliptical relies on low friction. To keep the friction low, the unit’s running belt, staging platforms,
and internal mechanisms must be as clean as possible.
