Section E
95
Maintenance Schedules
CAUTION:
Servicing is to be done with appliance disconnected
from the supply circuit. To disconnect, turn all controls
to the off position, then remove the plug from the outlet.
La Prudence:
Entretenir devrait être fait avec l’appareil débranché du
circuit de provision. Débrancher, tourner tous contrôles
au de la position, alors enlever le bouchon de la sortie.
Monthly Care and Service
To extend the life and appearance of your TRUE ZTX treadmill, we recommend that you
monthly:
1.
Clean the treadmill of dust and dirt that might accumulate under and behind the
treadmill. Vacuum small rubber particles from the soles of running shoes which
accumulate alongside the belt and behind the machine.
2.
Inspect the autowaxer for sufficient
wax in the wax channel.
a.
Lay treadmill on its side.
b.
Pull back the tread belt (on the
bottom of the treadmill) to expose
the wax channel.
c.
The wax channel should be at least
1/4” thick at its thinnest point.
d.
Feel along the full length of the wax
channel for consistent thickness.
e.
Call authorized service technician
to replace wax channel if it is less
than 1/4” thick at any point.
NOTE:
To prevent damage to the tread belt, do not allow the
treadmill to run without sufficient wax in the wax
channel.
Summary of Contents for ZTX 825
