Section E
98
Incline and Speed Calibration
The Incline and Speed Calibration mode is used to troubleshoot and calibrate the treadmill.
Calibration will cause the treadmill to speed up to 15 MPH and incline up to 15%.
CAUTION:
Keep area under the treadmill free from obstructions
because the deck returns to 0% grade when the
SAFETY KEY is placed. Failure to do so could cause
personal injury or damage to the machine.
La Prudence:
Garder le domaine sous le sans treadmill des obstructions
parce que le pont se retourne à 0% degré quand la clef
de sûreté est insérée. Echec pour ainsi faire pourrait
causer personnel blessure ou dommages à la machine.
NOTE:
Messages appear in the Message Center on the ZTX
825P and the ZTX 825HRC. The messages display
differently on the ZTX 825 and appear in the Primary
Display Window. They are shown below in parentheses.
1. Hold
while placing the SAFETY KEY onto the Keyboard
to enter the Calibration Mode.
The following messages will repeat themselves one at a time:
CALIBRATION
PRESS START
NOTE:
While in this mode,
and
can be used to
change the treadmill incline and speed. The SPEED
Window will display actual speed.
2. Press
to start calibration.
The treadmill will lower to zero incline and then start increasing incline to 15%
and speed to 15 MPH.
3. When the calibration is complete:
The following message will display in the Message Center:
CALIBRATION SUCCESSFUL
(PASS)
or to indicate an error in speed or incline:
INVALID INCLINE DATA
(bAd grAd dAtA)
INVALID SPEED DATA
(bAd SPd dAtA)
CALIBRATION ABORTED:
(CAL StOP)
NO SPEED SENSOR
(nO SPd SEnS)
Calibration
(CAL)
(PrSS)
(Strt)
Summary of Contents for ZTX 825
