11
Section A
Setting Up Your Treadmill
Treadmill Assembly
(Continued)
9.
Insert 4 screws and star
lock washers (1/4”-20 X 5/8”)
through the holes in the top
of the handrails and 2
self-drilling screws into
the holes in the bottom
of the handrails. Tighten
all 6 screws.
10. Remove the fibercore shock
pad from the gap between the
elevation rack and the frame.
To remove the shock pad:
a.
Follow the first 5 steps in the preliminary operating
instructions for the Manual Mode of your treadmill.
NOTE:
Because you are not standing on the tread belt you do not
need to connect the SAFETY KEY lanyard clip to your
clothing.
b.
Hold
while placing the SAFETY KEY onto the Keyboard
to enter the Calibration Mode.
The following messages will repeat themselves one at a time:
CALIBRATION
PRESS START
On the ZTX 825: CAL, PrSS, Strt.
c.
Use
to change the numbers in
the GRADE Window (Heart Rate
Window on ZTX 825) from 200
to approximately 160
d.
Pull the Shock Pad from between
the frame and the incline rack.
e.
Remove the SAFETY KEY and shut
the power switch off.
Summary of Contents for ZTX 825
