3.
Once the wheels have been properly secured, unfold the rollator frame by holding each
of its leg and pulling them apart. Continue this until the folded seat in the middle has
been straightened out.
4.
Then, insert the handlebars with forearm support into the
frame.
Before that, ensure that the handle bas are positioned
properly. Use the forearm supporter as a reference - the
shorter end of the supporter must be facing the same
direction as the front wheels of the frame; the longer side
must be facing the same side as the rear wheels.
5.
Once secured, insert the push and brake handles into the tubes found under the shorter
side of the forearm supporter. Remember that the push and brake handles must be facing
upwards.
After which, fit the coach bolts and knobs provided through the holes found on both tubes
to keep the handles in place. Please refer to the picture on the right for the correct arm
rest bolt arrangement.
Summary of Contents for Upright Mobility Walker
Page 1: ...Upright Mobility Walker...