Note: Make sure you reassemble the two pieces correctly or you will only get a round fan pattern.
4.
Remove the fan adjustment seal (#9). Clean if necessary.
4.9.3 Re-Assemble The Spray Gun
1. Insert the fan adjustment seal (#9).
2. Insert the fan adjustment ring and air distributor plate. (#7 and #8). If you have
separated these two pieces it is critical that the white air distributor plate is correctly
re-inserted into the fan adjustment ring. Note that the open slots on the air distributor
plate must be visible through the holes of the fan adjustment ring at the 12 o’clock
and 6 o
’clock
positions
.
Using the back end of the needle, move the distributor plate so that the round screw
hole is at the 5 o’clock position. DO NOT put the distributor plate and fan adjustment
ring together as show in the picture marked “incorrect”. You will only be able to
achieve a round spray pattern.
1. Place the Air Distributor (#6) on top of the paired fan adjustment ring and Air
Distributor plate.
2. Align the screw hole in the Air Distributor with the holes in the fan adjustment ring and
air distributor plate.
Summary of Contents for Apollo 7500 AtomiZer
Page 32: ...8 Diagram Parts List...
