3. Setup
3.1 Installing Air Relief Mechanism (Turbine Systems Only)
As previously noted, Apollo Models 725, 825, 835, 835VR, 1025, 1035, 1040VR,
1050, 1050VR, Power Series and Precision Series have an air relief mechanism
internally installed and
DO NOT
require an external air relief mechanism. All
other Apollo Models require the installation of Apollo Part # A7538A to the turbine
air outlet prior to operating The AtomiZer 7500 spray gun.
The air relief mechanism Part #A7538A must also be installed on ANY MAKE
turbine system that does not have an air relief mechanism installed. If using with
a system other than Apollo, please check with the manufacturer to determine if
a non-bleed spray gun can be safely operated on your system. If not, install Part
#A7538A before operating the 7500 AtomiZer spray gun.
A7538
To install Part #A7538A Air Relief Mechanism, first locate and remove the Air Hose Quick Connect.
Second, screw the air relief mechanism onto the turbine air outlet. Third, screw the Air Hose Quick Connect onto the Air
Relief Mechanism. Make sure to install the Air Relief Mechanism with the bleed hole pointing upwards. Failure to do so, will
blow dust and dirt around on the floor while you are spraying.
Summary of Contents for Apollo 7500 AtomiZer
Page 32: ...8 Diagram Parts List...