S. 15
Connecting the power supply
Ensure that the power socket provides 110V at 60Hz with a working circuit breaker
and a protective conductor connection, otherwise the system must not be oprated.
Before connecting the power supply make sure the water line is connected and working. Otherwise
the cooling system might be damaged. Turn on the power strip switch inside the cabinet and connect
the power plug to the wall socket. The screen should turn on for a short period of time if done
correctly. Now the computer can be turned on by pressing the powerbutton at the top of the
computer. After the boot process has finished the IQ-Software starts automatically.
Connect the Liquid Containers
You can connect up to six several liquid bags to the unit. The bags have to be placed on the shelf
within the cabinet. The opening of each bag must be placed downwards necessarily for the system to
work properly.
Carefully open the prepunched part of the bag marked with white stickers and take them out. Then
pull out the white round connectors and place them in the whole below the sticker.
The black connection ring needs to be hung up properly into the opening of the cartonage as shown
in the picture below. Note that the plastic bag must stay inside the cartonage, otherwise the liquid
can’t flow properly.
To connect the transparent tubes to the system simply push them towards the connection of the
bags until you feel a slight resistance.
The tubing is numbered from one to six. These numbers are necessary to assign the flavors to the
touch buttons within the software later.