AEV350, MEV350
TWO PART VALVE HOUSING,
AUTO AND MANUAL EXPULSION
Installation and User Guide
32210-001 REV A
Trulife
www.trulife.com
Page 3 of 4
Steps 5-7 pertain only to the auto expulsion valve insert:
5.
Use a 3mm hex key to remove the set screw.
6.
Carefully remove the small inner spring and rubber ball.
7.
Clean components with water and mild detergent, or isopropyl alcohol. Ensure
that the rubber ball and inner sealing surface of the button is free of any debris or
residue.
Re-assemble valve inserts, steps 1-3 pertain to the auto expulsion version:
1.
Lightly coat the rubber ball with petroleum jelly or synthetic lubricant.
2.
Place the ball, followed by the small spring into the valve button.
3.
Apply 1 drop of Loctite 242 or 243 (blue) to the threads of the set screw and screw
it in until it stops.
Remaining steps apply to both the Auto-expulsion and the manual expulsion valves:
4.
Place the large spring over the valve button, then press and hold it through the valve body while placing the small o-ring
over the lip on the opposite side of the button to retain it in place.
5.
Press the button a few times to ensure the o-ring is seated properly.
6.
Position the valve cover over the lower opening of the valve and press firmly until it snaps into place.
Warning: Failure to follow the installation and use procedures set forth above may lead to failure of the components subjecting
the user to a risk of serious personal injury.
