8
EN
Only competent and trained staff (experts) are permit-
ted to install and repair the Truma product and to carry
out the function test, at the same time observing the
installation and operating instructions and the currently
recognised technical regulations. Experts are persons
who, based on their specialist instruction and training,
their knowledge and experience with Truma products
and the relevant standards, can carry out the necessary
work properly and identify potential hazards.
Scope of delivery
Truma E-Kit
E-Kit fastening accessory kit
E-Kit screws kit
E-Kit electrical parts kit
Optional accessories
Duct adapter
Selecting a location
Dimensions
(All dimensions in mm)
270
600
Truma E-Kit
Figure 1
Truma E-Kit
190
260
123
Figure 2
Install the Truma E-Kit only in a location that is protected
against moisture and damp. Installation under washbasins or
water containers is not permitted.
Installation instructions
A water pipe may only be routed at a distance of 1.5 m from
the heater at the warm air duct.
The Truma E-Kit must not be installed in the driver’s cab of a
motor home.
The Truma E-Kit must always be installed so that it is easy to
access at all times for service work, and is also easy to re-
move and install.
The distance between the Truma E-Kit and surrounding furni-
ture items or vehicle components must be at least 6 mm at all
sides.
The warm air outlets of the Truma E-Kit must not be blocked.
There must be clearance of at least 30 cm to blow out the
warm air.
Depending on the installation situation, additional space must
be provided for connections (warm air and circulating air ducts).
The Truma E-Kit must be installed so that the driver or the
passengers cannot make contact with the appliance during
normal driving.
The operation of important vehicle components must not be
adversely affected.
The Truma E-Kit must not be installed directly under a wall
socket.
In order to prevent damage to components inside the appli-
ance, no cables or water lines may be attached to the appli-
ance’s housing.
Check whether the vehicle has a load-bearing floor, double
floor or false floor for securing the heater. If the floor is unsuit-
able, create a load-bearing surface beforehand (e.g. by gluing
a plywood board to the floor). The same requirements must
be observed for wall mounting.
The Truma E-Kit must only be installed in the vehicle with the
supplied mounting bracket.
Installation position
Floor mounting:
The Truma E-Kit may only be mounted on a level surface with
a maximum horizontal incline of ± 10°.
± 10°
Figure 3
A slanted installation position (incline > ± 10°) is not
allowed.
Wall mounting:
The Truma E-Kit may only be mounted horizontally on a wall.
The horizontal incline must not exceed ± 10°.
E
± 10°
Truma E-Kit
Figure 4
The electronics housing (E) must face downwards. A
upright and slanted installation position (incline > ± 10°)
is not allowed.
