12
Only qualified technicians may assemble and connect electri-
cal devices!
Remove the equipment pack (accessories) and check it is
complete:
1 instructions for installation and use
4 flat pin bushing 6.3 mm, insulated
1 connection cable 230 V, 1 m
4 mounting screws
4 washers
The device should be installed away from damp and wet. The
installation site should be clean, dry and well ventilated. The
device must stand horizontally and may not be wall-mounted!
Ensure that the ventilation slits remain free! Inadequate
ventilation can cause the device to overheat!
The designated room in which the device is to be installed
may not undercut the following dimensions as a minimum
clearance of 100 mm all-round must be observed.
PS 100 (200) Automatic
Length: 400 mm / Width: 360 mm / Height: 195 (242) mm
Attach the device securely with the supplied screws.
Connection
Before connecting or disconnecting the cables, the
supply lines to the battery and mains supply must be
disconnected!
Installation instructions
Safety instructions
This device contains parts that could cause sparks or a
light arc!
The device must be connected to the mains power supply
in accordance with the respective valid national installation
regulations.
The 230 V electrical connection must always be made
by an expert (in accordance with VDE 0100, part 721 or
prIEC 60364-7-721, for example, in Germany).
Ensure that the power supply has been disconnected! Discon-
nect the mains plug!
Only use the supplied parts and the specified cable cross-sec-
tions and fuses to connect the device!
Only use suitable and fully functional tools.
Only wire the device as specified in the supplied wiring diagram!
Installation
Installation in vehicles must accord with the technical and
administrative provisions of the individual country of use
(e.g. EN 1648). The national legislation and regulations must
be observed.
In other countries always observe the respectively valid
regulations.
