13
Cable lengths and cross-sections
Cable Cable
length *
Cable
cross-section
W 1
–
3 m
1.5 mm²
* Wire length = wire path x 2
12 V connection wires / handling the flat pin bushings
Remove 5 mm of the insulation
from the cable.
Push the flat pin bushing onto
the wire until it will go no fur-
ther – the bare part of the wire
must lie in the front terminal.
Now press the flat pin bushing
onto the wire using a suitable
crimping tool.
5 mm
Check that the flat pin bushings sit tight on the wire.
Energy source / consumer connection
Connect the device to the energy source (e.g. battery, dyna-
mo, charger) and the consumers (e.g. refrigerator) as shown
in the wiring diagram. Check that the terminals are connected
correctly.
Always position the fuses close to the energy source
(e. g. battery, dynamo, charger). Only use the specified
cable cross-sections (see table) and fuses of the correct
strength!
Connect the power cable to the 230 V main distributor of the
caravan, motorcaravan or boat.
Check all connections are tight.
Connect to the mains using the 230 V device plug of the
power cable.
Wiring diagram
12 V
230 V~
-
+
-
+
W 1
W 1
W 1
W 1
10 A
PS 35 (50) Automatic
12 V
12 V
X 1
X 2
X 2
12 V consumer
X 1 Device plug – mains input
X 2 Flat plug 6.3 mm
–
–
Summary of Contents for PS 35 Automatic
Page 51: ......
