7200791 Service Manual for the HELION
®
XENION
®
Surgical Lighting System GB
8
1 Important Information for the Service Technician
Only for trained and authorised
fitters
Servicing in accordance with
this service manual
Use original parts only
In case of problems
Defective parts
Repairs outside the scope of
the repair order
No unauthorised or
temporary repairs
1.1
1.1
1.1
1.1
1.1
Information for the service technician
Information for the service technician
Information for the service technician
Information for the service technician
Information for the service technician
This service manual is intended only for service technicians
trained and authorised by TRUMPF KREUZER Medizin Sys-
teme GmbH + Co. KG.
• Servicing must be carried out in steps according to this service
manual.
• The safety, reliability and performance of the equipment is only
ensured where TRUMPF KREUZER original parts are used.
• If, when dismantling, making repairs or settings, you encoun-
ter problems which are not covered by this service manual or
not covered in sufficient detail, you should immediately con-
tact your nearest TRUMPF KREUZER Customer Service Centre
for your own safety and that of the hospital staff and patients.
Only carry out repairs that you are familiar with from your
training and which are included in this service manual.
• Replace any defective parts with TRUMPF KREUZER original
parts.
If it should be necessary to replace parts outside the scope of
the repair order, discuss this work with the customer first.
• Unauthorised or temporary repairs are not permitted even if
requested by the customer.
Comply with all the requirements from the current laws, regu-
lations and standards.
• For information and to order spare parts please contact
TRUMPF KREUZER Service
(Telephone: +49 / (0) 180 / 225 4135).
1.2
1.2
1.2
1.2
1.2
TTTTTools and equipment required
ools and equipment required
ools and equipment required
ools and equipment required
ools and equipment required
• Basic equipment:
-
fitter’s tool set,
-
cordless screwdriver
• Measuring instruments:
-
luxmeter (for measuring light intensity),
-
voltmeter (for making electrical measurements).
• For fitting/dismantling heavy components:
-
Lifting equipment with a permitted load of at least 200 kg. The
lift must correspond at least to the height of the ceiling.
-
Ladder with necessary length.
• Accessories:
-
cable ties
