2. Rotate the die carrier (7) in the desired direction.
3. Retighten the clamping screw (14) by hand.
4. Check the penetration depth of the punch.
4.3
Nibbling with templates
The following requirements must be met when nibbling with tem-
plates:
■
The template must be at least 5 mm thick.
■
There must be a clearance of 15.5 mm between the contour
of the template and the contour to be nibbled out.
■
The nibbler must be guided in such a way that the exterior
cutout of the punch guide (5) always remains up against the
template.
■
Observe a minimum bending radius of 400 mm.
4.4
Producing interior cutouts
Ø
Produce start bore with at least a 65 mm diameter.
16
Nibbling with templates
E232en_06
