3. Rotate the carrier (20) by 360° as often as needed until the
cutting tools protrudes 0-3 mm out of the sliding sleeve (22).
4. One rotation (360°) corresponds to a height adjustment of
1.75 mm.
5. Retighten the clamping screw (7).
3.6
Select gear
Note
Depending on the material thickness, tensile strength and type of
workpiece, a different gear must be selected for machining.
Instead of in 2nd gear, 1st gear can always be worked with, but
never vice versa.
Damage to property due to turning the gear switch during
operation.
Damage to the gearbox can be a consequence.
Ø
Use the gear switch only when the motor is running down or
at rest.
Damage to property due to too high a stroke rate
Damage to the motor due to an overload can be a
consequence.
Ø
Observe the specifications in the technical data .
1
On switch
2
Off switch
3
Release switch
Fig. 9659
1. Put the machine into a stable position.
2. Switch on the machine briefly:
16
Selecting cutting tool
E681en_02
CAUTION
CAUTION
