6
Assembly
H
H
• The base must be fixed to a stable, solid fixed, flat and
level workbench before starting by means of two holes
(
H
) and two screws (not included).
To determine the place where the iron
base of the support will be mounted, take into
consideration the following points:
• Make sure there is a suitable power outlet nearby.
• If the drill stand is to be permanently mounted to a
workbench, make sure the workbench is of adequate
height, strong, and stable enough to support the weight of
the drill, stand, and workpiece.
• Taking into account the length and width of the material
to be machined, make sure there is enough space at each
end and around the machine to accommodate the largest
piece of material to be machined safely.
• Mark the two mounting holes on the workbench surface
with a pencil.
• Remove the base and drill the two holes for 5/16”
(8 mm) diameter at the marks made.
• Secure the base to the work base with bolts. 5/16”
(8 mm) diameter, flat nuts and washers (not included).
• Gradually tighten each bolt one at a time to fully seat the
cabinet base.
ENGLISH
CAUTION
