8
Setup
A
C
B
D
1
H
F
K
D
2
I
E
G
J
L
• Make sure that the grinder is switched
off during the assembly process.
• Fix the angle grinder (
A
) between the swivel arms (
B
)
with the two sets of screws and nuts (
C
) suitable for the
diameter of the holes in the grinding head (M6, M8 or
M10).
• Once the screws have been assembled, tighten them
sufficiently so that the grinder does not move freely.
• Make sure to place the screws with
bushing as shown in picture
1
; only in this way you will
obtain the proper tightening on the grinder.
• Place the guard shaft (
J
) in the rear hole of the moving
body and secure it by tightening the screw (
K
).
• To prevent movement of the guard (
J
) tighten the two
parallel screws (
L
).
• Connect the grinder, turn it on for a few seconds and
turn it off. Check that all screws, nuts and bolts of the
assembly are tight..
• Using a screwdriver, turn both leveling screws (
D
) until
they make contact with the grinder body.
• Adjust the leveling screws to ensure that the cut-off
wheel is at 90° to the base. Use a square (
E
) to make this
adjustment.
• To ensure that the grinder is properly
mounted, the two leveling screws must make firm contact
in the body of the grinder.
• Once the disc is adjusted to 90°, tighten all the swing
arm screws and the leveling screws to prevent the grinder
from moving.
• Using the square, check that the disc (
F
) is aligned to the
center of the groove (
G
) of the iron base. Or lower the
lever (
H
) to verify that the disc passes through the slot and
does not contact the iron base.
• If the disc does contact the iron base, loosen the two
screws on the movable body (
I
) and turn it to the left or
right until the disc is aligned with the groove.
Screw
Swivel
arm
Bushing
Nut
Assembly of the grinding machine
1
ENGLISH
CAUTION
CAUTION
CAUTION
