Truper 12483, Manual

8

Use only spare parts and accessories recommended by 

the manufacturer.  In case the tool is not working, repairs 

should be carried out in a                                Authorized 

Service Center.

Maintenance

Repairs

• Always disconnect the tool before cleaning.

• Never use water or other liquids. Use only a brush.

• To prevent overheating the motor, clean the ventilation 

slots regularly.

• Double-check all the tool components are securely 

fastened.

• The housing should not be cracked or damaged.

• Double-check the power cable is not cut or peeled.

• After a prolonged use the grease on the tool head 

should be replaced in a

                                Authorized Service Center.

Carbon Brush Replacement

• Replace worn (burnt, broken or smaller than 0.19” long) 

carbon brushes. Use new carbons.

• When changing carbons always change both carbons at 

the same time.

• Remove worn carbons from the housing. Clean dust with 

compressed air.

• Set the new carbons in a reverse order. Carbons shall 

easily fall into the carbon housing.

• After setting up new carbon brushes let the grinder 

running a couple of minutes with no load. This way the 

carbon brushes will adjust better.

• Use only original                                 spare carbon 

brushes, designed specifically with the right hardness and 

electric resistance for each type of motor. Carbon brushes 

with different specifications may damage the motor.

Store the tool tidy in a dry place and protected against 

dust and water.

Storage

ENGLISH