8
Start Up
Operation
• Turn on the compressor and fill it.
• Regulate the air compressor output pressure to 75 PSI and
110 PSI
The tool operates with this pressure
range. If operating with a higher pressure ranges the useful
life of the tool will be decreased.
• Load the cartridge as indicated on page 7.
• Use a piece of scrap wood to verify the
tool works correctly.
CAUTION
WARNING
A
B
C
ENGLISH
• Having your finger away from the trigger position the tool
and press the contact lock against the surface to be used (
A
).
• Without lifting the tool press the trigger to shoot (
B
).
• Immediately release the trigger and lift the tool (
C
).
• Position the tool back for subsequent shots.
• In case the nails are not penetrating deep enough, slightly
lift the air pressure until reaching the right penetration force.
Remember not to exceed 110 PSI
• Or, slowly turn the depth control (
D
) until gaining the
expected penetration force.
WARNING
Depth regulator
The driving depth of the nails is adjustable. To adjust the
depth, use the transmission depth adjustment wheel (
D
).
Disconnect the tool from the air supply
before attempting to disassemble any parts.
• Turn the depth adjustment wheel left or right to change
the driving depth
• Reconnect the tool to the air supply
• Insert a test nail after each adjustment to the desired
depth.
D
CAUTION
Flush
Too Deep
