3
ENGLISH
Safety Warnings
for the Use of Pneumatic Tools
Keep your work area clean, tidy and well lit.
Cluttered and dark areas may cause accidents.
Never use the tool in explosive environments
or near flammable liquids.
Sparks generated by the tool may cause explosion or fire.
Keep children and visitors at a safe distance
when using the tool.
Distractions may cause loosing control
and cause accidents.
Avoid contact with power lines and circuits.
Find and avoid both power lines and circuits,
especially hidden wires and grounded devices.
Stay alert, use care and common sense.
Do not rely on your knowledge of the tool.
Do not get distracted while operating it.
It could cause accidents.
Do not use the tool when tired or under the influence of
drugs, alcohol or medication.
One second of distraction while using the tool
may cause severe injuries.
Use the tool with guards and protective devices in place
and in good working conditions.
Failure to comply with these measures may cause
severe injuries.
Secure and support the work piece properly.
Use bench vices and a stable working area.
Do not force the tool.
It will do the job better and safer at the rate
for which it was intended.
Store the tool in a safe place away from the reach of
children.
Power tools are dangerous for inexperienced
people.
Dress properly.
Loose clothing, jewelry or long hair may get
caught in moving parts.
Keep your hands away from rotating and/or mobile
parts.
Failure to comply with this safety measure
exposes you to severe personal injury.
Use adequate personal protection.
Using safety glasses, anti-dust mask, safety non-skid
shoes, helmet and earplugs used in adequate conditions
considerably reduce the risk of injury.
Disconnect the air hose from the tool servicing,
changing devices or storing.
Reduce the risk of unintentional starting causing
accidents.
Never use a tool if the switch is not working or is not
properly assembled.
You are exposed to severe personal injury.
Do not overreach.
Good footing and balance allow you to gain better
control of the tool in unexpected situations.
Never pull the air hose.
Do not use it to carry or disconnect the tool pulling out
the air supply. Damaged or tangled hoses can burst
and shoot residues towards the operator.
Avoid accidental start up.
Make sure the air supply tool is switched off
before connecting or moving the tool.
Remove vices before starting the tool.
Additional tools or vices set into a moving part
may cause severe injury.
Service the tool and verify it is in excellent working
conditions.
Carefully check all moving parts, alignment and
assembly. Make this periodically. Look for damaged or
malfunctioning parts to immediately be repaired.
Accessories.
Use only accessories or spare parts recommended in
this MANUAL or certified by .
Never leave a running tool unattended.
Switch off and disconnect the tool from the air supply
after operating and before putting it aside. Avoid
severe injury.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING
DANGER
DANGER
DANGER
DANGER
Summary of Contents for 14031
Page 20: ...10 Notes...
