Truper 14037, Manual

7

Start Up

ENGLISH

• Turn the adjusting screw (

A

) in a counterclockwise 

direction to increase the volume of the material to be 

sprayed.

• Turn the adjusting screw in a clockwise direction to 

diminish the volume of the material to be sprayed.

Volume Selector

• Start the compressor.

• Press the trigger (

B

) to open the air flow and start 

suctioning the product from the jar. Point the paint gun 

towards a piece of cardboard until the spray flows.

• Release the trigger to stop the spray flow.

• To get the best result keep the gun always level and 

parallel to the surface (

C

). Keep the nozzle 8” – 11”  away 

from the surface and spray evenly from side to side and up 

and down.  Do not spray in an angle otherwise the paint 

may run through the surface. Do soft and uniform passes. 

When spraying large surfaces use a crossed pattern (

D

).

• Move the gun with a steady and uniform speed. Fast 

movements produce thinner layers. Slow movements 

produce thicker layers.

• Apply one layer at a time. In the event of needing a 

second layer read the drying recommendations from the 

product manufacturer before applying an extra layer. Remember that to get a better finish applying two thin layers is better 

than only one thick layer.

• When spraying small areas turn the adjusting screw to lessen the volume of the material. This prevents using too much 

paint and over-spraying

• To assure a uniform application, do not pause while spraying an object when possible.

• Do not tilt the paint gun in an angle higher than 45°.

Start up

Spraying Techniques

B

C

D

A