3
EBA-650-250
EBA-650-260
16054
16142
6”
Class I
60 Hz
50 Hz
3 500 r/min
3 000 r/min
Bench Grinder
H05VV-F 3GX0.75 mm
2
with insulating temperature of 221°F
1,68 A
1/2 Hp
50 minutes work per 20 minutes idle. Maximum 6 hours per day
Code
Description
Wheel Diameter
Voltage
Frequency
Speed
Current
Power
Duty cycle
Conductors
Insulating
220 V
Technical Data
Power Cord Grips used in this product: Type “Y”
Tool Build Quality: Basic Insulation
Thermal insulation on motor winding: Class F
ENGLISH
Power Requirements
From 0 and up to 10 A
From 10 and up to 13 A
From 13 and up to 15 A
From 15 and up to 20 A
18 AWG
16 AWG
14 AWG
8 AWG
16 AWG
14 AWG
12 AWG
6 AWG
3 (one grounded)
From 6 ft to 49 ft | Higher than 49 ft
Ampere
Capacity
Number of
Conductors
Extension Gauge
WARNING
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a Authorized Service Center.
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
This tool is equipped with a grounded 3-part power cord or to
a grounded electric power system.
When using an extension cable, verify the gauge is enough for
the power that your product needs. A lower gauge cable will cause voltage drop in
the line, resulting in power loss and overheating. The following table shows the
right size to use depending on cable’s length and the ampere capability
shown in the tool’s nameplate. When in doubt use the next higher
gauge.
WARNING
WARNING
