• Feeding direction is pushing towards the planer front as
indicated in the graph. Do not try to do it from the rear.
• Support the work piece on the table extension using both
hands. Push the piece inside the planner. Do not take it off
the table.
• Use care. Do not put hands inside the
planer to avoid severe injuries.
• The outward pieces can be set on return rollers to return the
pieces to the operator and facilitate making gradual cuts in the
same piece.
• Consider the following table to get a
quality job and prevent accidents:
Feeding length (minimum):
5’’
Feeding width (maximum):
12-1/2’’
Feeding thickness:
0,2’’ - 6’’
Cutting depth (maximum):
1/8’’
Feeding speed:
26,2 fpm*
*(feet per minute)
Start Up
10
• Thickness in the work piece will depend on the distance
of the cutter head and the work piece.
• To adjust the distance, turn the cutting depth control
hand shank (
J
).
• The cutting depth adjustment can be read in the depth
scale (
K
). The grading of the adjustment is 1/16” per hand
shank turn.
• Always start the job making a light planning cut. Cutting
depth in the subsequent steps may be increased up to
1/8”. However, remember that a light cut produces a finer
finish than a thick cut.
• Never carry out planning above 1/8” in
one step. Neither try to work wood smaller than 5” long.
Always wear protective face mask. Do not work on pieces
with a thickness smaller than 3/16“. Do not work pieces
with a thickness greater than 6”.
Cutting Depth Adjustment
J
K
Feeding the Work Piece
CAUTION
WARNING
WARNING
ENGLISH
Summary of Contents for 16240
Page 13: ...13 Notas ESPA OL...
Page 14: ...Notas 14 ESPA OL...
Page 29: ...13 Notes ENGLISH...
Page 30: ...Notes 14 ENGLISH...
