Truper 16683, Manual

8

Carbon brush replacement

ENGLISH

Maintenance

• Always disconnect the tool before cleaning.

• Never use water or other liquids. Use only a brush.

• To prevent the motor to overheat clean the ventilation slots regularly.

• Check all the tool components are perfectly fixed.

• The housing should not be cracked or damaged.

• Double-check the power cable is not cut or peeled.

• After a prolonged use the grease on the tool head should be replaced in a

               Authorized Service Center.

Use only spare parts and accessories recommended by the manufacturer. In 

the event the tool is not working, repairs should be performed in a

                                Authorized Service Center

Repairs

Neatly store the tool in a dry place and protected from dust and water .

Storage

• Carbon Brushes should be periodically checked and when worn, replaced 

always in a                                 Authorized Service Center.

• After replacing the carbon brushes request to inspect if the new carbon 

brushes can move freely in the carbon housing. Also request to run the tool 5 

minutes to make even the contact with the carbon brushes and the commuter.

• Use only original                                 spare carbons specifically designed 

with the hardness and resistance adequate for each type of motor.  Carbons 

that are out of specification could damage the motor.

• Both carbons should be changed simultaneous.