Truper 16684, Manual

8

Carbon brush replacement

ENGLISH

Maintenance

• Always disconnect the tool before cleaning.

• Never use water or other liquids. Use only a brush.

• To prevent the motor to overheat clean the ventilation slots regularly.

• Check all the tool components are perfectly fixed.

• The housing should not be cracked or damaged.

• Double-check the power cable is not cut or peeled.

• After a prolonged use the grease on the tool head should be replaced in a

             Authorized Service Center.

Use only spare parts and accessories recommended by the manufacturer. In 

the event the tool is not working, repairs should be performed in a

                                Authorized Service Center

Repairs

Neatly store the tool in a dry place and protected from dust and water .

Storage

• Replace worn (burnt, broken or smaller than 0.19” long) carbon brushes. Use 

new carbons.

• When changing carbons always change both carbons at the same time.

• Remove worn carbons from the housing. Clean dust with compressed air.

• Set the new carbons in a reverse order.  Carbon should easily fall into the 

carbon housing.

• After setting up new carbon brushes let the grinder to run a couple of 

minutes with no load.  This way the carbon brushes will adjust better.

• Use only original                                spare carbon brushes, designed 

specifically with the right strength and electric resistance for each type of motor. 

Carbon brushes with different specifications may damage the motor.