Power Requirements
3
ESRE-1/4N
16871
Class II
60 Hz
Industrial die grinder
18 AWG x 2C with insulating temperature of 221 °F
50 minutes work and 20 minutes idle.
Maximum 6 hours per day.
5 A
0.8 HP
11 300 RPM - 30 000 RPM
Code
Description
1/4”
Jaws capacity
Voltage
Frequency
Current
Power
Speed
Duty cycle
Conductors
Insulating
IP20
IP Grade
Power cord grips used in this product: Type “Y”.
Build quality: Double insulation
Thermal insulation on motor winding: Class E
120 V
ENGLISH
WARNING
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a Authorized Service Center.
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
Technical Data
Tools with double insulation and reinforced insulation are equipped with
a polarized plug (one prong is wider than the other). This plug will only fit in the right way
into a polarized outlet. If the plug cannot be introduced into the outlet, reverse the plug. If it
still doesn’t fit, call a qualified electrician to install for you a polarized outlet. Do not alter the
plug in any way. Both insulation types eliminate the need of both a grounded third power
cord with three prongs or a grounded power connection.
When using an extension cable, verify the gauge is enough for the
power that your product needs. A lower gauge cable will cause voltage drop in the line, resulting in power loss and overheating. The
following table shows the right size to use depending on cable’s length and the ampere capability shown in the tool’s nameplate. When
in doubt use the next higher gauge.
WARNING
WARNING
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
18 AWG(*)
16 AWG
14 AWG
8 AWG
16 AWG
14 AWG
12 AWG
6 AWG
3 (one grounded)
from 6 ft to 49 ft | higher than 49 ft
Ampere
Capacity
Number of
Conductors
Extension gauge
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE-2006
WARNING
When operating power tools outdoors, use a grounded
extension cable labeled “For Outdoors Use”. These extensions are especially designed
for operating outdoors and reduce the risk of electric shock.
Summary of Contents for 16871
Page 9: ...9 Notas ESPA OL...
Page 21: ...9 ENGLISH Notes...
