Truper 17247, Manual

Air Brush AERO-35

(not included)

• Before operating the compressor, double check is set on 

a flat, leveled and solid surface, with good ventilation and 

away from flammable objects like drapes, etc.

• Keep at least 12” free space around the compressor to 

allow air to flow.

1• Connect the power cord into the power outlet. Make 

sure it is not damaged or turned into an obstacle a 

tripping hazard.

2• Connect the end of the air hose (Not included) to the 

compressor air outlet. (1)

3• Connect the other end of the air hose to the air brush 

inlet (Not included). (2)

4• Press the power switch into the “I” position to switch on 

the compressor.  Check there are no leaks in the air 

connections.

• Turn off the compressor to repair any leak detected.

                           Use this compressor only with an air 

brush. Do not use it with any other type of painting 

equipment.

• Connect the plug into the power source.

• Press the switch into the “I” position to start the 

compressor.

• Adjust air pressure lifting the pressure regulator (

A

) to 

un-block it. Turn it until getting the desired pressure 

indicated in the gauge (

B

). Then, press the regulator 

downwards to block it back.

• When finishing using the compressor, set the switch into 

the “O” position (off). Release the air remaining inside and 

disconnect the air brush.

• Carry out maintenance in the air brush following the 

manufacturer instructions.

Note:

 The compressor will automatically switch off if hot 

in excess, or if overloaded. In this case, press the switch 

into the “O” position and wait for it to cool down before 

starting it again.

7

Assembly

Start Up

1

2

A

A

B

CAUTION

ENGLISH