Truper COMP-12S, Manual

3

COMP-12S

13824

60 Hz

17,6 lb

1/4” fast coupling

1,7 A

0,8 CFM - 40 PSI

0,5 CFM - 90 PSI

100 PSI

3,1 gal

127 V

Class I

14 AWG x 3C with 221 °F insulation temperature

13,7” x 13,1”

1/3 Hp

IP20

A

B

ENGLISH

Oil-free air compressor

Code

Description

Voltage

Frequency

Weight

Air Connections

Current

Maximum Pressure

Air Flow

Tank Capacity

Measurements

Motor Power

Conductors

Insulation

IP Grade

Power Cord Grips used in this product: Type “Y”.

Tool Build Quality: Basic insulation

Thermal insulation on motor winding: Class B

WARNING

WARNING

Avoid the risk of electric shock or severe injury. When the power cable gets damaged 

it should only be replaced by the manufacturer or at a                                 Authorized Service Center.

The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.

Do not expose to rain, liquids and/or dampness.

Before gaining access to the terminals all power sources should be disconnected.

                             The equipment shall be grounded while in use

to prevent an electric shock.

• Connect plug into a properly grounded contact or outlet as shown in 

example 

A

. Not all contacts or outlets are properly grounded. If not sure, 

contact with a certified electrician.

• If the outlet you want to use with the equipment has two poles (2 orifices), 

FOR ANY REASON AT ALL DO NOT REMOVE OR ALTER THE PLUG’S EARTH 

TERMINAL. Use a temporary adapter as shown in example 

B

 and always 

connect the earth conductor’s lug as indicated.

                          When using an extension cable, verify the gauge is enough for the power that your product needs. A lower gauge 

cable will cause voltage drop in the line, resulting in power loss and overheating. The following table shows the right size to use 

depending on cable’s length and the ampere capability shown in the tool’s nameplate. When in doubt use the next higher gauge.

WARNING

CAUTION

When operating power tools outdoors, use a                       grounded extension cable labeled 

“For Outdoors Use”. These extensions are especially designed for operating outdoors and reduce the risk of 

electric shock.

WARNING

All the cabling, power connections and the ground connection of the system shall be in 

compliance with the Mexican Official Standard 

NORMA OFICIAL MEXICANA NOM-001-SEDE-2012,

INSTALACIONES ELÉCTRICAS (UTILIZACIÓN)

 or with the local codes and municipal by-laws.

WARNING

From 0 and up to 10 A

From 10 and up to 13 A

From 13 and up to 15 A

From 15 and up to 20 A

18 AWG

16 AWG

14 AWG

8 AWG

16 AWG

14 AWG

12 AWG

6 AWG

3 (one grounded)

From 6 ft to 49 ft         |         Higher than 49 ft

Ampere

Capacity

Number of

Conductors

Extension Gauge

Technical Data

Power Requirements

* It is safe to use only if the extensions have a built-in artifact for over current protection.

AWG = American Wire Gauge. Reference: NMX-J-195-ANCE